Module - Anti-Lock Brake Control: Installation

WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the scan tool into the new module. For additional information, refer to MODULE CONFIGURATION .

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn its strategy.

NOTE: Clean the top of the HCU before installing the new module.

NOTE: Clean the harness and module sides of the electrical connector before connecting. Clean and lubricate the weather seal gasket using Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (WA-10) meeting Ford specification ESE-M1C171-A.

Fig 1: Installing Anti-Lock Brake Module

Courtesy of FORD MOTOR CO.

Fig 2: Installing Bracket Hooks To Frame And Lower HCU

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.