Coupling - Spring Lock: Connect

Inspect and clean both coupling ends. Install new O-rings and garter springs if necessary.

Fig 1: Installing New O-Rings And Garter Springs
Courtesy of FORD MOTOR CO.

NOTE: Lubricate the O-rings with clean engine oil.

Fig 2: Fitting Male Fitting Into Female End

Courtesy of FORD MOTOR CO.

Fit the (A) male fitting into the (B) female end and push until the garter spring snaps over the flared end of the female fitting.
Verify coupling engagement by pulling on the lines.

Fig 3: Verifying Coupling Engagement
Courtesy of FORD MOTOR CO.
Install the fuel line clip.

Fig 4: Installing Fuel Line Clip
Courtesy of FORD MOTOR CO.