LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2005 >> Focus ZX3 SES, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Safety Belt System >> General Procedures >> Replacement of the Weld Nut and Reinforcement
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Replacement of the Weld Nut and Reinforcement

    NOTE: If the B- or C-pillar safety belt anchor nuts or reinforcements are stripped or missing, a new nut/reinforcement plate must be installed.
  1. Expose the suspect anchor point.
  2. Drill out 28 mm (5/16 inch) diameter access holes adjacent to the weld nut clearance hole.
  3. Thread a length of copper welding wire through the clearance hole and position to secure the weld nut and washer.
  4. Use MIG wire feed welder and plug weld a 7/16 inch weld nut and standard washer in place at the 2 8 mm (5/16 inch) holes.
  5. Metal finish as necessary.
  6. Install the restraint system.
  7. Carry out the Functional Tests. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals