Spark Plugs: Installation
- Adjust the spark plug gap as necessary.
- Install the 6 spark plugs.
- Tighten to 15 Nm (11 lb-ft).
- Apply dielectric grease to the inside of the spark plug wire boots before attaching to the spark plugs.
- Connect the 6 spark plug wires to the spark plugs.
- Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
CAUTION:
Spark plug wires must be connected to the correct spark plug. Mark spark plug wire locations before removing them.
CAUTION:
Make sure the spark plug boots are positioned so the spark plug wires do not contact the exhaust manifold.