LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2006 >> Focus ZX4 ST >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM and connect the electrical connectors.
    2. CAUTION: Make sure that the PCM electrical connectors do not unlock when installing the GEM module.
  2. Position the GEM module and install the 2 nuts.
    • Tighten to 10 Nm (89 lb-in).
  3. Install the passenger side lower footwell trim panel.
    Fig 1: Locating Passenger Side Lower Footwell Trim Panel
    G04652603Courtesy of FORD MOTOR CO.
  4. Install the glove compartment.
    Fig 2: Locating Glove Compartment Bolts
    G04652604Courtesy of FORD MOTOR CO.
  5. Install the cowl side trim panel.
    Fig 3: Locating Cowl Side Trim Panel
    G04652605Courtesy of FORD MOTOR CO.
  6. Install the instrument panel side trim.
    Fig 4: Installing Instrument Panel Side Trim
    G04652606Courtesy of FORD MOTOR CO.
  7. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  8. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PATS .
scientia non olet · About LEMON Manuals