LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2006 >> Freestar Base >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. '1. Install the PCM and the 2 retaining nuts.
    • Tighten to 5 Nm (44 lb-in).
  2. Connect the PCM electrical connector and tighten the bolt.
    • Tighten to 7 Nm (62 lb-in).
  3. Position the power steering reservoir and install the bolt.
    • Tighten to 10 Nm (89 lb-in).
  4. Position the suction accumulator and install the 3 bolts.
    • Tighten to 5 Nm (44 lb-in).
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  6. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
scientia non olet · About LEMON Manuals