RH Power Sliding Door Module (RH PSD Module)
RH POWER SLIDING DOOR MODULE (RH PSD MODULE) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1336 | C-pillar ajar switch RR circuit open | GO to PINPOINT TEST L. |
| B1342 | ECU is defective | CLEAR the DTCs. CARRY OUT the RH PSD Module self-test. If DTC B1342 is retrieved, INSTALL a new RH PSD module. |
| B2016 | PSD latch switch open circuit | GO to PINPOINT TEST J. |
| B2337 | Vehicle signal indicating park while VSS present | REFER to INTRODUCTION - GASOLINE to diagnose the VSS circuits. REFER to AUTOMATIC TRANSAXLE/TRANSMISSION or AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS to diagnose PARK signal. |
| B2238 | Broken cable detected | GO to PINPOINT TEST C. |
| B2270 | PSD exceeded time allowed to cinch door (exceeded time allowed to reach primary latch position after reaching secondary latch position) | GO to PINPOINT TEST D. |
| B2271 | PSD did not reach full open position during self-test | GO to PINPOINT TEST E. |
| B2363 | Position sensor system failure | GO to PINPOINT TEST F. |
| B2365 | B-pillar PSD open/close switch circuit short to ground | GO to PINPOINT TEST H. |
| B2366 | PSD open/close switch circuit short to ground | GO to PINPOINT TEST I. |
| B2367 | PSD on/off switch open circuit | GO to PINPOINT TEST R. |
| B2483 | Enable signal open circuit (Park) | GO to PINPOINT TEST K. |
| B2589 | No PSD C-pillar ajar switch detected on closing and door reversed | GO to PINPOINT TEST L. |
| B2591 | No PSD detent (Latch) switch detected on unlatch | GO to PINPOINT TEST M. |
| B2592 | Door not pulled into primary during power close and high duty cycles | GO to PINPOINT TEST N. |
| B2593 | Door reversed while closing due to an obstacle | GO to PINPOINT TEST O. |
| B2594 | No movement was detected after an unlatch during a power open operation | GO to PINPOINT TEST P. |
| B2603 | PSD not pulled into primary latch position during power close during self-test | GO to PINPOINT TEST Q. |
| B2605 | Disable signal open circuit - VSS greater than 5 km/h (3 mph) | GO to PINPOINT TEST S. |
| B2859 | PSD position out of range | INSTALL a new PSD position sensor. CLEAR the DTCs. CARRY OUT the RH PSD Module self-test. If DTC B2859 is retrieved, INSTALL a new RH PSD Module. |