Control Module: Service and Repair

Four Wheel Drive (4WD) Control Module

Four Wheel Drive (4WD) Control Module:

Removal and Installation
1. Open the glove compartment, press in on the sides and lower it to gain access.
2. From below the LH side instrument panel, remove the hush panel.
3. Disconnect the four wheel drive (4WD) control module harness connector.
4. Remove the 4WD control module nuts.
^ To install, tighten to 7 Nm (62 inch lbs).
5. Remove the 4WD control module and bracket.
6. To install, reverse the removal procedure.