LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Edge SE, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Disassembly And Assembly Of Subassemblies >> Main Control Assembly >> Disassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Main Control Assembly: Disassembly

    NOTE: Note the location of the different length bolt for assembly.
  1. Remove the 6 bolts and the cover assembly.
    2. Fig 1: Locating Cover Assembly Bolts
    GF0031824Courtesy of FORD MOTOR CO.
    NOTE: Note the location of the different length bolts for assembly.
  2. Remove the 5 bolts and the transfer plate assembly.
    3. Fig 2: Locating Transfer Plate Assembly Bolts
    GF0031825Courtesy of FORD MOTOR CO.
  3. Remove and discard the valve body separator plate.
    4. Fig 3: Identifying Valve Body Separator Plate
    GF0031826Courtesy of FORD MOTOR CO.
    NOTE: Note the location of the check balls for assembly.
  4. Remove the 7 check balls from the valve body.
    5. Fig 4: Locating Check Balls From Valve Body
    GF0031827Courtesy of FORD MOTOR CO.
  5. Remove the lower valve body assembly.
    6. Fig 5: Identifying Lower Valve Body Assembly
    GF0031828Courtesy of FORD MOTOR CO.
  6. Remove and discard the lower valve body separator plate and gasket.
    7. Fig 6: Identifying Lower Valve Body Separator Plate & Gasket
    GF0031829Courtesy of FORD MOTOR CO.
  7. Remove the manual valve from the valve body.
    8. Fig 7: Identifying Manual Valve From Valve Body
    GF0031830Courtesy of FORD MOTOR CO.
    CAUTION: Remove the valves by tapping the valve body on the palm of the hand to slide the valves out of the bores. It may be necessary to remove the valves and springs using a pick. If it is necessary to use a pick, use extreme caution to prevent damaging the valves or valve bores. If necessary, disassemble parts of the main control valve body in small groups. Take special care when handling the main control components, since they are the most precise and delicate parts of the transaxle. Neatly arrange the parts as they are removed to avoid mixing similar pieces.
    CAUTION: Do not stone or polish any valves. If the valves do not move freely, install a new assembly.
  8. Remove the individual valves and springs from the main control valve body and lower valve body by removing the retaining clips. See the main control valve body assembly illustration for valve and spring locations. Clean valves, springs, main control valve body and lower valve body.
scientia non olet · About LEMON Manuals