LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Expedition RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Disassembly And Assembly Of Subassemblies >> Pump Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pump Assembly: Assembly

    NOTE: Prior to installation, lightly lubricate the pump gears with clean automatic transmission fluid.
  1. Install the pump gears with the dot facing the pump plate assembly.
    2. Fig 1: Locating Pump Gear Dots
    GF0022681Courtesy of FORD MOTOR CO.
  2. Install a new pump body outer seal.
    3. Fig 2: Locating Pump Body Outer Seal
    GF0022679Courtesy of FORD MOTOR CO.
  3. Assemble the plate assembly and the pump body assembly.
    • Tighten to 15 Nm (11 lb-ft).
    4. Fig 3: Locating Plate Assembly To Pump Body Bolts
    GF0022678Courtesy of FORD MOTOR CO.
    CAUTION: Make sure the seal ends are correctly positioned together and not separated.
  4. Install the 2 front pump seal rings onto the stator support. Make sure the seals are fully seated in the stator support seal grooves and the seal ends are oriented 180 degrees apart.
    5. Fig 4: Front Pump Stator Support Seals
    GF0022677Courtesy of FORD MOTOR CO.
  5. Install the pump outer diameter front pump O-ring seal.
    6. Fig 5: Locating Pump Outer Diameter Front Pump O-Ring Seal
    GF0022800Courtesy of FORD MOTOR CO.
  6. Using the special tool, install the front pump seal.
    7. Fig 6: Identifying Special Tool
    GF0022682Courtesy of FORD MOTOR CO.
    NOTE: Lightly lubricate the thrust washer with petroleum jelly to hold it in place during assembly.
  7. Install the pump thrust washer.
    8. Fig 7: Locating Front Pump Washer
    GF0022675Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals