LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Focus ST >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> In-Vehicle Servicing >> Timing Drive Components >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Timing Drive Components: Installation

  1. Install the camshaft drive gears and the bolts. Do not tighten the bolts at this time.
    2. Fig 1: Locating Camshaft Sprocket Bolts
    G03897782Courtesy of FORD MOTOR CO.
  2. Install the LH timing chain guide and bolts.
    • Tighten to 10 Nm (89 lb-in).
    3. Fig 2: Identifying Bolts And LH Timing Chain Guide
    G03897780Courtesy of FORD MOTOR CO.
  3. Install the timing chain.
    4. Fig 3: View Of Timing Chain
    G03897779Courtesy of FORD MOTOR CO.
  4. Install the RH timing chain guide.
    5. Fig 4: Locating RH Timing Chain Guide
    G03897778Courtesy of FORD MOTOR CO.
  5. Install the timing chain tensioner and the bolts. Remove the paper clip to release the piston.
    • Tighten to 10 Nm (89 lb-in).
    6. Fig 5: Locating Timing Chain Tensioner Bolts And Paper Clip
    GF0024080Courtesy of FORD MOTOR CO.
    CAUTION: The special tool (303-465) is for camshaft alignment only. Using this tool to prevent engine rotation can result in engine damage.
  6. Using the flats on the camshafts to prevent camshaft rotation, tighten the camshaft drive gears bolts.
    • Tighten to 72 Nm (53 lb-ft).
    7. Fig 6: Locating Camshaft Sprocket Bolts
    GF0024081Courtesy of FORD MOTOR CO.
  7. Install the front cover. For additional information, refer to Engine Front Cover .
scientia non olet · About LEMON Manuals