LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Focus ST >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM and connect the electrical connectors.
    2. CAUTION: Make sure that the PCM electrical connectors do not unlock when installing the GEM module.
  2. Position the GEM module and install the 2 nuts.
    • Tighten to 10 Nm (89 lb-in).
  3. Install the passenger side lower footwell trim panel.
    4. Fig 1: Locating Passenger Side Lower Footwell Trim Panel
    GF0039461Courtesy of FORD MOTOR CO.
  4. Install the glove compartment.
    5. Fig 2: Locating Glove Compartment Bolts
    GF0039460Courtesy of FORD MOTOR CO.
  5. Install the cowl side trim panel.
    6. Fig 3: Locating Cowl Side Trim Panel
    GF0038976Courtesy of FORD MOTOR CO.
  6. Install the instrument panel side trim.
    7. Fig 4: Installing Instrument Panel Side Trim
    GF0039459Courtesy of FORD MOTOR CO.
  7. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
  8. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
scientia non olet · About LEMON Manuals