LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Taurus SE >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the 2 bolts.
    • Tighten to 5 Nm (44 lb-in).
    • Install the gasket.
  2. Connect the PCM electrical connector and tighten the bolt.
    • Tighten to 7 Nm (62 lb-in).
  3. Connect the evaporative emission (EVAP) canister purge valve return tube at the intake manifold.
    4. Fig 1: Locating Evaporative Emission Canister Purge Valve Return Tube
    GF0019775Courtesy of FORD MOTOR CO.
  4. Position the RH cowl extension panel and install the 3 screws.
  5. Install the clip on the RH cowl extension panel.
    6. Fig 2: Locating Cowl Extension Panel Clip
    GF0019576Courtesy of FORD MOTOR CO.
  6. Position the RH cowl panel grille and install the 3 retaining clips (2 shown).
    7. Fig 3: Locating Cowl Panel Grille Retaining Clips
    GF0019575Courtesy of FORD MOTOR CO.
  7. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  8. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
  9. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PATS article.
scientia non olet · About LEMON Manuals