System Specifications

TIMING CHAIN TENSIONER

Install the timing chain tensioner and the 2 bolts. Remove the paper clip to release the piston.
Tighten 10 Nm (89 lb-in).

CRANKSHAFT PULLEY/TIMING GEAR MOUNTING BOLT

Install a new crankshaft pulley bolt. Using the Crankshaft Damper Holding Tool to hold the crankshaft pulley in place, tighten the crankshaft pulley bolt in 2 stages:
Stage 1: Tighten to 100 Nm (74 lb-ft).
Stage 2: Tighten an additional 90 degrees (one-fourth turn).

TIMING COVER(ENGINE FRONT COVER)

Install the engine front cover. Tighten the 22 bolts in the sequence shown to the following specifications:
Tighten the 8-mm bolts to 10 Nm (89 lb-in).
Tighten the 13-mm bolts to 48 Nm (35 lb-ft).