Starting System DTCS

PCM DIAGNOSTIC TROUBLE CODES (DTC) LIST

DTC	Description	Source	Action
P0512	Starter Request Circuit - Circuit has Power With the Ignition in the OFF Position	PCM	CARRY OUT the Ignition Switch Component Test. Refer to appropriate COMPONENT TESTING article. If necessary, INSTALL a new ignition switch. If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to power.
P0705	TR Sensor Circuit Failure	PCM	Refer to the appropriate Automatic Transmission article for the procedure.
P1702	TR Sensor Circuit Failure	PCM	Refer to the appropriate Automatic Transmission article for the procedure.
P1705	TR Sensor Circuit Failure	PCM	Refer to the appropriate Automatic Transmission article for the procedure.
P0830	Clutch Pedal Switch A Circuit	PCM	REFER to INTRODUCTION - GASOLINE MODELS article.
P0833	Clutch Pedal Switch B Circuit	PCM	REFER to INTRODUCTION - GASOLINE MODELS article.

PASSIVE ANTI-THEFT SYSTEM (PATS) DIAGNOSTIC TROUBLE CODES (DTC) LIST

DTC	Description	Source	Action
B1213	Anti-Theft Number of Programmed Keys is Below Minimum	PCM	REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET article.
B1232	Transceiver Failure	PCM	REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET article.
B1342	ECU is faulted	PCM	INSTALL a PCM. REFER to ELECTRONIC ENGINE CONTROLS article.
B1600	Passive Anti-Theft System (PATS) Key Transponder Signal is Not Received	PCM	REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET article.
B1601	PATS Received Incorrect Key-Code From Ignition Key Transponder	PCM	REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET article.
B1602	PATS Received Invalid Format of Key-Code From Ignition Key Transponder	PCM	REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET article.
B1681	PATS Transceiver Module Signal is Not Received	PCM	REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET article.
B2103	Antenna Not Connected	PCM	REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET article.
B2431	Transponder Programming Failed	PCM	VERIFY if the correct PATS key is being used. If the PATS key is defective, use a new key for programming. REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET article.