Principles of Operation: Notes
WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
Configurable modules accommodate a variety of vehicle options, eliminating the need for many unique modules for one vehicle line. These modules must be configured when replaced as part of a repair procedure.
Configurable modules should not be exchanged between vehicles since the settings are unique to each vehicle. Failure to configure a new module may result in improper operation and/or any of the following DTCs setting:
- B2477 - sets when a body/chassis module is not configured or is configured incorrectly.
- B2900 - sets when there is a VIN mismatch between the module with the B2900 and the PCM. The stored VIN in either module may be incorrect.
- P0602, P0605 and/or P1639 - sets when the PCM vehicle identification (VID) block is not configured.
- U0300 - sets when the configuration between 2 or more modules do not match.
- U2050 and/or U2051 - sets when a valid strategy/calibration is not present.
The following are the 3 different methods of configuration:
- Programmable module installation (PMI)
- Module reprogramming ("flashing")
- Programmable parameters
Some modules do not support all 3 methods.