Inspection and Verification

WARNING: This page is about a different car, the 2010 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

This section provides step-by-step module configuration procedures. Carry out the Programmable Module Installation (PMI) procedures when another workshop manual directs to carry out configuration or when DTCs from the list below are present:

NOTE: Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous Memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.

DTC CHART

DTC	Description	Source	Action
B2477	Module Configuration Failure	ABS module Audio Control Module (ACM) Front Display Interface Module (FDIM) Instrument Cluster (IC) Restraints Control Module (RCM) Smart Junction Box (SJB)	CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
B2900	VIN Mismatch	ABS module	CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0602	Powertrain Control Module Programming Error	PCM	CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0605	Internal Control Module Read Only Memory(ROM ) Error	PCM	CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1639	Vehicle ID Block Corrupted, Not Programmed	PCM	CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300	Internal Control Module Software Incompatibility	PCM	CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050	No Application Present	ABS module ACM Front Controls Interface Module (FCIM) FDIM IC Occupant Classification System Module X(OCSM) PCM RCM SJB	CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050	No Application Present	HVAC module	INSTALL a new HVAC module. REFER to CLIMATE CONTROL .
U2051	One or More Calibration Files Missing/Corrupt	ACM FCIM FDIM RCM OCSM PCM	CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2100:00	Initial Configuration Not Complete: No Sub Type Information	APIM	CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING .
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	APIM	CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING .