Body Control Module (BCM)
BCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1175:01 | Drivers Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B1176:01 | Passenger Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B11C0:01 | Driver Side Rear Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B11C1:01 | Passenger Side Rear Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B12C2:11 | Puddle Lamp: Circuit Short To Ground | GO to PINPOINT TEST D . |
| B1306:01 | Liftgate Ajar Switch: General Electrical Failure | GO to PINPOINT TEST E . |
| B1313:11 | Interior Lighting Output: Circuit Short To Ground | GO to PINPOINT TEST C . |
| B1313:15 | Interior Lighting Output: Circuit Short To Battery or Open | If the interior courtesy lamps are inoperative, GO to PINPOINT TEST C
. If the interior courtesy lamps stay on continuously, GO to PINPOINT TEST F . |
| U1000:00 | Solid State Driver Protection Active - Driver Disabled: No Sub Type Information | The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The Body Control Module (BCM) cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first . After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, INSTALL a new BCM . REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation . |
| All other DTCs | - | REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES . |