DTC Chart
NOTE:
modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous Memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC CHART
| DTC | Description | Source | Action |
|---|---|---|---|
| U0300 | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U0300:4A | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U2024:54 | Control Module Cal-Config Data |
|
CARRY OUT PMI . refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U2050 | No Application Present |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U2051 | One or More Calibration Files Missing/Corrupt |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT APIM programming. Refer to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING in this information. |
| U2100:55 | Initial Configuration Not Complete |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U2100:55 | Initial Configuration Not Complete |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT APIM programming. Refer to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING in this information. |
| U3000:46 | Control Module Calibration/Parameter Memory Failure |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |
| U3002:62 | Vehicle Identification Number - signal compare failure |
|
CARRY OUT PMI . Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) in this information. |