Inspection and Verification

WARNING: This page is about a different car, the 2012 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.

This service information provides step-by-step module configuration procedures. Carry out the Programmable Module Installation (PMI) to carry out configuration or when DTCs from the list below are present:

NOTE: Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous Memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.

DTC CHART

DTC	Description	Source	Action
U0300	Internal Control Module Software Incompatibility	RCM PSCM	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U0300:4A	Internal Control Module Software Incompatibility	PCM	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2024:54	Control Module Cal-Config Data	PCM	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2050	No Application Present	OCSM TPM	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2051	One or More Calibration Files Missing/Corrupt	OCSM	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2100:00	Initial Configuration Not Complete: No Sub Type Information	ABS module ACM FCDIM PSCM RCM RFA	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2100:00	Initial Configuration Not Complete: No Sub Type Information	APIM	CARRY OUT APIM programming. REFER to Accessory Protocol Interface Module (APIM) Programming .
U2100:55	Initial Configuration Not Complete	ABS module	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2100:55	Initial Configuration Not Complete	ABS module	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	ABS module ACM BCM FCDIM IPC PSCM	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	APIM	CARRY OUT APIM programming. REFER to Accessory Protocol Interface Module (APIM) Programming .
U3000:46	Control Module Calibration/Parameter Memory Failure	RCM	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .
U3002:62	Vehicle Identification Number - signal compare failure	PSCM RCM	CARRY OUT PMI. REFER to Programmable Module Installation (PMI) .