Front Controls Interface Module (FCIM) - With Navigation
FRONT CONTROLS INTERFACE MODULE (FCIM) - WITH NAVIGATION DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to PINPOINT TEST AE . |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to PINPOINT TEST AT . |
| U2013:63 | Switch Pack: Circuit / Component Protection Time-Out | GO to PINPOINT TEST F . |
| U2014:41 | Control Module Hardware: General Checksum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U2014:41 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) in this service information. REPEAT the self-test. |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | REFER to MODULE COMMUNICATIONS NETWORK - MODULE CONFIGURATION article. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to PINPOINT TEST AH . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to PINPOINT TEST AI . |