LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Taurus SE >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Module Configuration System >> General Procedures >> Accessory Protocol Interface Module (APIM) Programming >> Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)

NOTE:
  • If a new Accessory Protocol Interface Module (APIM) is being installed, install a new APIM before carrying out the following procedure. For additional information, refer to INFORMATION SYSTEM AND ENTERTAINMENT SYSTEM Article.
  • When carrying out the programming procedures, follow the scan tool on-screen directions.
  • Make sure the battery is fully charged before carrying out the programming steps.
  • A hardwired internet connection is strongly recommended when programming.
  • If unable to complete programming because operation stops or errors are received, internet browser settings may need to be configured. From the on-line OASIS tab, select the "Service Tips" tab, then select "SYNC Software Programming" under "Job Aids".
NOTE:
  • For APIM flash programming:
  • The scan tool and a USB male A to male A cable (CCMUSB2-AM-AM-10 or equivalent) are required.
  • The flash procedure deletes any paired phones that were in the SYNC® system.
  • The file for the flash needs to be downloaded from the on-line database. Allow for extra time for the file to download. The files are approximately 80 megabyte.
    NOTE: The IDS program must be closed before attempting to program the APIM.
  1. Open a session for the vehicle from the technician service publication web site, and run On-Line Automotive Service Information System (OASIS) using "Read VIN and DTC's".
  2. From the OASIS tab, select the "SYNC" button.
  3. There are 3 available options for APIM programming:
    • Standard (latest version of current software and applications): Use this option to update the APIM to the latest software level.
    • Custom (show what's available, and let me choose): Use this option to show all the available options that can be programmed, or if a Technical Service Bulletin (TSB) directs for specific software version to be programmed.
    • Module Replacement (restore software for newly installed hardware): Use this option when the APIM has been replaced.
  4. After selecting 1 of the 3 options (Standard, Custom or Module Replacement), click the "Read SYNC" button to verify the current APIM, Vehicle Interface Processor (VIP) and Consumer Interface Processor (CIP) software levels.
    • The versions are compared to a on-line database. After the comparison, the available software is displayed.
    5. NOTE: Do not disconnect the Vehicle Communication Module (VCM) or the USB cable during APIM programming.
    NOTE: If unable to complete programming because operation stops or errors are received, interned browser settings may need to be configured. From the on-line OASIS tab, select the "Service Tips" tab, then select "SYNC Software Programming" under "Job Aids".
  5. When carrying out the programming procedures, follow the scan tool on-screen directions.

    Select the "Program SYNC" button to begin the APIM programming process.

  6. Follow the scan tool on-screen directions for APIM programming.
    • After programming is complete the scan tool displays "Programming has been completed successfully."
scientia non olet · About LEMON Manuals