Inspection and Verification
This service information provides step-by-step module configuration procedures. Carry out the Programmable Module Installation (PMI) procedures in this service information when another appropriate service information directs to carry out configuration or when DTCs from the below list are present:
NOTE:
Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC CHART
| DTC | Description | Source | Action |
|---|---|---|---|
| B2477 | Module Configuration Failure |
|
CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| B2900 | VIN Mismatch |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P0602 | Powertrain Control Module Programming Error |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P0605 | Internal Control Module Read Only Memory (ROM) Error |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P1635 | Tire/Axle Out of Acceptable Range |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P1639 | Vehicle ID Block Corrupted, Not Programmed |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U0300 | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U0300:00 | Internal Control Module Software Incompatibility: No Sub Type Information |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U0300:51 | Internal Control Module Software Incompatibility: Not Programmed |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2050 | No Application Present |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2051 | One or More Calibration Files Missing/Corrupt |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING . |
| U2100:56 | Initial Configuration Not Complete: Invalid/Incompatible Configuration |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING . |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information |
|
INSTALL a new RCM. REFER to SUPPLEMENTAL RESTRAINT SYSTEM article. CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure |
|
INSTALL a new RCM. REFER to SUPPLEMENTAL RESTRAINT SYSTEM article. CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U3002:62 | Vehicle Identification Number: Signal Compare Failure |
|
CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |