LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Escape XLS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Module Configuration System >> General Procedures >> Accessory Protocol Interface Module (APIM) Programming >> Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)

NOTE:
  • If a new Accessory Protocol Interface Module (APIM) is being installed, install a new APIM before carrying out the following procedure. For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEMS article.
  • When carrying out the programming procedures, follow the scan tool on-screen directions.
  • Make sure the battery is fully charged before carrying out the programming steps.
  • A hardwired internet connection is strongly recommended when programming.
NOTE:
  • For APIM flash programming:
    • The scan tool and a USB male A to male A cable (CCMUSB2-AM-AM-10 or equivalent) are required.
    • The flash procedure deletes any paired phones that were in the SYNC® system.
    • The file for the flash needs to be downloaded from the on-line database. Allow for extra time for the file to download. The files are approximately 80 megabyte.
scientia non olet · About LEMON Manuals