Module Configuration and Parameter Chart

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
APIM	7D0	Yes	Yes	No	None
ABS module	760	Yes	Yes	IVD initialization	None
ACM	727	Yes	Yes	No	Auxiliary 1 Engine noise enhancement enable/disable
BCM	726	Yes	Yes	Ambient lighting calibration Rear view camera calibration	Autolamp delay Auto lock/unlock Auto relock DRL configuration Global open/close Lock feedback light Mislock horn One/two stage unlock Passive entry/lock/start Park lock control Rear fold mirror Remote start enable/disable Key enable/disable Rain sensing enable Keypad enable Piezo Sounder feedback Power lock enable Valet mode Power point max time/time out Perimeter alarm Approach detection
CCM	764	Yes	Yes	Radar horizontal and vertical alignment calibration	None
DSP	783	Yes	Yes	No	None
DACMC (integrated with ACM)	7D5	Yes	Yes	No	None
DC/ DC control module (voltage control module [VQM])	746	Yes	Yes	No	None
DDM	740	Yes	Yes	Windows initialization	None
DSM	744	Yes	Yes	No	None
SCMG	712	Yes	Yes	No	None
EPB module	756	No	No	EPB apply and release	None
SCME	776	Yes	Yes	No	None
FCDIM (4.2-inch screen)	7A5	Yes	Yes	No	None
FCIM	7A7	Yes	Yes	No	None
GWM	716	Yes	Yes	No	None
GPSM	701	Yes	Yes	No	None
HUD module	7B2	No	No	No	None
HSWM	714	Yes	Yes	No	Temperature setpoint (vehicles built 6/24/15 or later) Normal or warm Warmer or hot
IPC	720	Yes	Yes	No	Remote start feature configuration Climate settings driver seat passenger seat steering wheel Trailer brake gain warning
IPMA module	706	Yes	Yes	Camera calibration	None
IPMB	7B1	Yes	Yes	Camera calibration LIN new model initialization	None
OCSM	765	No	No	OCSM re-zero	None
PAM (integrated with BCM)	736	Yes	Yes	No	None
SCMH	713	Yes	Yes	No	None
PSCM	730	Yes	Yes	No	None
PCM	7E0	Yes	Yes	Misfire Monitor Neutral Profile Correction procedure	None
PDM	741	Yes	Yes	Windows initialization	None
PRB	766	No	No	No	None
RTM	751	Yes	Yes	No	None
RCM	737	Yes	Yes	No	Driver Beltminder status Passenger Beltminder status
SODL	7C4	Yes	Yes	No	Blockage enabled Enable/disable configuration
SODR	7C6	Yes	Yes	No	Blockage enabled Enable/disable configuration
SCCM	724	Yes	Yes	No	None
TBM	757	No	No	No	None
TRM	791	Yes	Yes	No	None
TCCM	761	No	No	No	None