Powertrain Control Module (PCM): Installation
All vehicles
- Install the PCM and the 2 nuts.
- Tighten to 8 Nm (71 lb-in).
- Connect the 3 PCM electrical connectors.
- Install the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
- Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
- Reprogram the Passive Anti-Theft System (PATS). Carry out the Parameter Reset procedure. For additional information, refer to
ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS)
.
GTDI vehicles
- Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
NOTE:
If the Programmable Module Installation (PMI) procedure was not successful in downloading the data from the vehicles original PCM, then the oil life data of the vehicle is lost. If this occurs, and the oil life cannot be determined through service history or customer interview, it is recommended the vehicle engine oil and filter be changed and the oil change minder reset.