Engine Control Module: Service and Repair

Powertrain Control Module (PCM)









Removal

1. NOTE: PCM installation DOES NOT require new keys or programming of keys, only a Parameter Reset of the Passive Anti-Theft System (PATS).

Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to Information Bus. Programmable Module Installation (PMI)

2. Remove the Air Cleaner (ACL) outlet pipe and the ACL (Air Cleaner) assembly.

3. Disconnect the 3 PCM electrical connectors.

4. Remove the 2 bolts and the PCM.

Installation

1. Install the PCM and the 2 bolts.
- Tighten to 8 Nm (71 lb-in).


2. Connect the 3 PCM electrical connectors.

3. Install the ACL (Air Cleaner) outlet pipe and the ACL (Air Cleaner) assembly.

4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to Information Bus. Programmable Module Installation (PMI)

5. Reprogram the PATS (Passive Anti-Theft System). Carry out the Parameter Reset procedure. For additional information, refer to Antitheft and Alarm Systems.