Remote Function Actuator (RFA) Module
| DTC | Description | Action |
|---|---|---|
| B102B:05 | Passive Key: System Programming Failure | Less than 2 keys are programmed. PROGRAM additional keys (minimum of 2 keys must be programmed). REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT (419-01B Passive Anti-Theft System (PATS), General Procedures). |
| B10C1:24 | Left Front Unlock Pull Switch: Signal Stuck High | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10C2:24 | Left Rear Unlock Pull Switch: Signal Stuck High | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10C3:24 | Right Front Unlock Pull Switch: Signal Stuck High | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10C4:24 | Right Rear Unlock Pull Switch: Signal Stuck High | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10C5:24 | Trunk Unlock Pull Switch: Signal Stuck High | For vehicles with power liftgate, REFER to: BODY CLOSURES (501-03 Body Closures, Diagnosis and Testing). For vehicles without a power liftgate, REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10C6:1F | Exterior Trunk Antenna: Circuit Intermittent | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10C7:1F | Interior Trunk Antenna: Circuit Intermittent | REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) (419-01B Passive Anti-Theft System (PATS), Diagnosis and Testing). |
| B10C8:1F | Interior Centre Antenna: Circuit Intermittent | REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) (419-01B Passive Anti-Theft System (PATS), Diagnosis and Testing). |
| B10C9:1F | Interior Front Antenna: Circuit Intermittent | REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) (419-01B Passive Anti-Theft System (PATS), Diagnosis and Testing). |
| B10CA:1F | Left Rear Door Handle Antenna: Circuit Intermittent | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10CB:1F | Right Rear Door Handle Antenna: Circuit Intermittent | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10D1:24 | Left Front Lock button: Signal Stuck High | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B10D3:24 | Right Front Lock button: Signal Stuck High | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B11CC:51 | Immobilizer Keyless Vehicle Secret Key: Not Programmed | There is no BCM
ID stored in the RFA
module. CARRY OUT a parameter reset, then CYCLE the ignition and ATTEMPT to start the vehicle. REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET (419-01B Passive Anti-Theft System (PATS), General Procedures). |
| B12EE:11 | Liftgate/Tailgate/Trunk Release: Circuit Short To Ground | REFER to: BODY CLOSURES (501-03 Body Closures, Diagnosis and Testing). |
| B1361:31 | Front Right Door Handle Lock Circuit: No Signal | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1365:31 | Front Left Door Handle Lock Circuit: No Signal | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1367:31 | Right Rear Door Handle Unlock Circuit: No Signal | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B136F:31 | Left Front Door Handle Unlock Circuit: No Signal | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1370:23 | Door Handle Ground Supply: Signal Stuck Low | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1370:24 | Door Handle Ground Supply: Signal Stuck High | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1372:31 | Left Rear Door Handle Unlock Circuit: No Signal | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1373:31 | Front Right Door Handle Unlock Circuit: No Signal | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1399:05 | Personalized Key Synchronization: System Programming Failure | ERASE and PROGRAM all of the customer's keys. REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT (419-01B Passive Anti-Theft System (PATS), General Procedures). or REFER to: KEY PROGRAMMING USING TWO PROGRAMMED KEYS (419-01B Passive Anti-Theft System (PATS), General Procedures). |
| U0010:00 | Medium Speed CAN Communication Bus: No Sub Type Information | The module cannot communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC
). VERIFY the integrity of the connectors and wiring. Refer to SYSTEM WIRING DIAGRAMS
Wiring Diagrams Cell 14 for schematic and connector information. If no faults are found, INSTALL a new RFA
module. REFER to: REMOTE FUNCTION ACTUATOR (RFA) MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to PINPOINT TEST A |
| U0300:00 | Internal Control Module Software Incompatibility: No Sub Type Information | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC
is retrieved again, INSTALL a new RFA
module. REFER to: REMOTE FUNCTION ACTUATOR (RFA) MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U201B:54 | Control Module Calibration Data #2: Missing Calibration | CHECK the vehicle service history for recent service actions related to this module. This DTC
sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION (418-01 Module Configuration, Description and Operation). If there have been no recent service actions, INSTALL a new RFA module. REFER to: REMOTE FUNCTION ACTUATOR (RFA) MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U201F:00 | External Receiver: No Sub Type Information | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| U201F:13 | External Receiver: Circuit Open | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| U201F:87 | External Receiver: Missing Message | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK the vehicle service history for recent service actions related to this module. This DTC
sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION (418-01 Module Configuration, Description and Operation). If there have been no recent service actions, INSTALL a new RFA module. REFER to: REMOTE FUNCTION ACTUATOR (RFA) MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | CHECK the vehicle service history for recent service actions related to this module. This DTC
sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION (418-01 Module Configuration, Description and Operation). If there have been no recent service actions, INSTALL a new RFA module. REFER to: REMOTE FUNCTION ACTUATOR (RFA) MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U3000:49 | Control Module: Internal Electronic Failure INSTALL a new RFA module. | REFER to: REMOTE FUNCTION ACTUATOR (RFA) MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U3002:81 | Vehicle Identification Number: Invalid Serial Data Received | CHECK the vehicle service history for recent service actions related to this module. This DTC
sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION (418-01 Module Configuration, Description and Operation). If there have been no recent service actions, INSTALL a new RFA module. REFER to: REMOTE FUNCTION ACTUATOR (RFA) MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U3003:62 | Battery Voltage: Signal Compare Failure | GO to PINPOINT TEST B |