Front Controls Interface Module (FCIM)
FRONT CONTROLS INTERFACE MODULE (FCIM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B00D5: 01 | Restraint System Passenger Disable Indicator: General Electrical Failure | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B00D5: 01 is still present, INSTALL a new Front Controls Interface Module (FCIM). REFER to Front Controls Interface Module (FCIM) . REPEAT the self-test. |
| B113C: 11 | Hazard Switch Illumination: Circuit Short To Ground | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B113C: 11 is still present, INSTALL a new Front Controls Interface Module (FCIM). REFER to Front Controls Interface Module (FCIM) . REPEAT the self-test. |
| B1202: 01 | Restraint System Passenger Enable Indicator: General Electrical Failure | CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B1202: 01 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) . REPEAT the self-test. |
| U0155: 00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test V . |
| U0257: 00 | Lost Communication With Front Controls/Display Interface Module: No Sub Type Information | GO to Pinpoint Test AC . |
| U0423: 00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | RETRIEVE and FOLLOW other DTCs present in the Instrument Panel Cluster (IPC). |
| U2013: 63 | Switch Pack: Circuit/Component Protection Time-Out |
NOTE:
Do not press any FCIM buttons when carrying out the self-test. CLEAR the DTCs. REPEAT the self-test. If DTC U2013: 63 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM)
. REPEAT the self-test. |
| U201A: 51 | Control Module Main Calibration Data: Not Programmed | REFER to MODULE CONFIGURATION . |
| U3000: 41 | Control Module: General Checksum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U3000: 41 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) . REPEAT the self-test. |
| U3000: 42 | Control Module: General Memory Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U3000: 42 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) . REPEAT the self-test. |
| U3003: 16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AD . |
| U3003: 17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AE . |