LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2013 >> Explorer Police Interceptor, AWD >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> Anti-Theft System DTCS >> Passive Anti-Theft With Intelligent Access >> RFA Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

RFA Module

DTC DESCRIPTION - RFA MODULE

DTC Description Action
B10C7:01 PATS Target Identifier: Not Programmed GO to PINPOINT TEST D .
B10C8:01 Interior Centre Antenna: General Electrical Failure GO to PINPOINT TEST D .
B10C9:01 Interior Front Antenna: General Electrical Failure GO to PINPOINT TEST D .
B10D7:05 PATS Key: System Programming Failure GO to PINPOINT TEST A .
B10D7:31 PATS Key: No Signal This DTC sets during an RFA  module self-test if 2 programmed Intelligent Access (IA) keys are not detected inside the vehicle. CHECK each IA key individually to see if it operates the vehicle. If an IA key does not operate the vehicle, PROGRAM that key. Key Programming Using Diagnostic Equipment  . If 2 programmed IA  keys are not present inside the vehicle, DISREGARD this DTC.
B10D8:51 PATS Key Less Than Minimum Programmed: Not Programmed If other PATS  DTCs are present, address them first. If DTC  B10D8:51 is the only DTC present, PROGRAM additional keys (minimum of 2 keys must be programmed). Key Programming Using Diagnostic Equipment  . CLEAR the DTCs. REPEAT the self-test.
B10D9:11 PATS Transponder: Circuit Short To Ground GO to PINPOINT TEST B .
B10D9:12 PATS Transponder: Circuit Short To Battery GO to PINPOINT TEST B .
B10D9:31 PATS Transponder: No Signal GO to PINPOINT TEST B .
B10D9:87 PATS Transponder: Missing Message GO to PINPOINT TEST B .
B10DA:51 PATS PCM Identifier: Not Programmed There is no BCM  ID stored in the RFA  module. CARRY OUT a parameter reset, Refer to Passive Anti-Theft System (PATS) Parameter Reset , then CYCLE the ignition and make an attempt to start the vehicle. CLEAR the DTCs  . REPEAT the self-test.
B10DA:61 PATS PCM Identifier: Signal Calculation Failure There is an incorrect BCM  ID stored in the RFA  module. CARRY OUT a parameter reset, Refer to Passive Anti-Theft System (PATS) Parameter Reset , then CYCLE the ignition and make an attempt to start the vehicle. CLEAR the DTCs  . REPEAT the self-test.
U201F:31 External Receiver: No Signal GO to PINPOINT TEST C .
All other RFA  module DTCs - REFER to DTC CHART: RFA .
scientia non olet · About LEMON Manuals