Module COMMMUNICATIONS Network DTCS

DTC INDEX

DTC	Description	Source	Action
U0001:88	High Speed Controller Area Network (HS-CAN) Communication Bus; Bus Off	ABS module C-CM	The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring, Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.
U0028:08	Vehicle Communication Bus A: Bus Signal/Message Failures	RCM	The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring, Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.
U0028:88	Vehicle Communication Bus A: Bus Off	RCM	The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring, Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.
U0073	Control Module Communication Bus A Off	HCM	The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring, Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.
U0073:00	Control Module Communication Bus A Off	TCM	The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring, Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.
U3000:88	Control Module: Bus Off	APIM	The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). CLEAR the DTC. REPEAT the Network Test with the scan tool. VERIFY the integrity of the connectors and wiring, Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.