Module Configuration and Parameter Chart

The charts describe specific module configuration information:

Direct Configuration

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
APIM	7D0	Yes	Yes	No	None
APIM (Touchscreen)	7D0	Yes	Yes	No	Trailer tow Trailer module
ABS module	760	Yes	Yes	IVD initialization	None
ACM	727	Yes	Yes	No	None
BCM	726	Yes	Yes	No	Battery type Cargo door alarm disable (hinged cargo door) Configurable unlocking (hinged cargo door and sliding doors)
DDM	740	No	No	No	None
FCIM	7A7	No	No	No	None
FCDIM	7A5	Yes	Yes	No	Trailer tow
GPSM	701	Yes	Yes	No	None
HCM	734	No	No	No	None
HVAC module	733	No	No	No	None
IPC	720	Yes	Yes	No	Display language Digital speedometer
IPMB (if equipped)	7B1	Yes	Yes	No	Trailer module
OCSM	765	No	No	OCS re-zero	None
PAM	736	No	No	No	None
PSCM	730	No	No	No	None
PCM	7E0	Yes	Yes	Yes	VIN
PDM	741	No	No	No	None
RCM	737	Yes	Yes	No	None
SODL	7C4	Yes	Yes	No	None
SODR	7C6	Yes	Yes	No	None
SASM	797	No	No	No	None
TRM (vehicles built before 1/26/14)	791	No	No	No	None
TRM (vehicles built after 1/26/14)	791	Yes	Yes	No	Bad LED configuration LIN bus enable

Body Control Module (BCM) and Instrument Panel Cluster (IPC) Car Configuration

NOTE: The BCM and IPC have a unique procedure to set Car Configuration Parameters. Configuration changes made will affect several modules. If the car configuration is changed in the BCM or IPC, an adaptive learning of the car configuration may be required in some modules (such as ABS module or RCM), depending on the changed parameter.

NOTE: On the scan tool, first select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Retrieve the Vehicle Configuration Data. Next select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Modify and Reinstate Vehicle Configuration Data. Change parameters as needed.

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Car Configuration Parameters
BCM	726	Yes (through Car Configuration Parameters. Refer to BODY CONTROL MODULE (BCM)	Yes	No	NOTE: Do not change car configuration parameters except those listed below. Trailer towTrailer moduleGlobal open/closeBulkheadTire sizeBattery type (must also be enabled in BCM direct configuration)Default display language (must also be enabled in IPC direct configuration)Remote start enable/disablePerimeter alarm
IPC	720	Yes	Yes	No