ATEQ TPMS Reset Procedure

Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
Turn ignition switch to ON position with engine OFF.
Turn the hazard flashers on then off three times within 10 seconds. If the reset mode has been entered successfully, the horn will sound once, the system indicator will flash and a message is shown in the information display.
Place TPM3 on the Left Front tire wall at the valve stem. Press the "TEST" button. The horn will sound briefly to indicate that the tire pressure sensor has been recognized by the Driver's Door Module (DDM).

NOTE: Do not wait more than 2 minutes between training each sensor. If the wait time is more than 2 minutes the DDM will stop and the training procedure must be repeated from the beginning.

Within 2 minutes after the horn sounds, place TPMS3 on the Right Front tire wall at the valve stem. Then press the test button to train the Right Front tire pressure sensor. Repeat procedure for Right Rear and Left Rear tires.
Training is complete after the horn sounds for the last tire trained (driver's side rear tire), the system indicator stops flashing, and a message is shown in the information display.