Normal Operation and Fault Conditions
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets.
PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U2012:56 | Car Configuration Parameter(s): Invalid/Incompatible Configuration | Sets if the vehicle configuration information sent from the BCM does not match what is stored in the ABS module. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | Sets if the vehicle configuration information sent from the BCM (specifically adaptive cruise control and collision mitigation by braking) does not match what is stored in the ABS module. |
| U2300:51 | Central Configuration: Not Programmed | Sets due to incomplete or improper module programming procedures. |
| U2300:54 | Central Configuration: Missing Calibration | Sets when the IMU Calibration routine has not been carried out. |
| U2300:55 | Central Configuration: Not Configured | Sets due to incomplete or improper module programming procedures. |
| U2300:56 | Central Configuration: Invalid/Incompatible Configuration | Sets if the vehicle configuration information sent from the BCM does not match what is stored in the ABS module. |
| U2300:64 | Central Configuration: Signal Plausibility Failure | Sets due to incomplete or improper module programming procedures. |