TPMS Reset Procedures: Notes

NOTE: If tire pressure sensor is replaced, it will need to be trained. If the vehicle has different front and rear tire pressures, the tire pressure has to be adjusted and the TPM sensors has to be trained. If the vehicle has the same tire pressure on the front and rear tires, the tire pressure monitoring system is not affected by wheel and tire rotation.

NOTE: Do not use the TPMS reset procedure outlined in the Owner's Manual as this procedure will not program new sensors to the module.

When the tire pressure warning light comes on solid and message center displays "LOW TIRE PRESSURE", check the air pressure of all tires and adjust to the specified cold pressure listed on vehicle certification label (found on driver's door or door pillar). Drive the vehicle at 20 mph (32 km/h) for at least 2 minutes. The TPM sensor Activation procedure may also be used in place of driving. See TIRE PRESSURE SENSOR ACTIVATION . Make sure the warning light goes off.