Vehicles With Am/Fm/Cd/Sync/Touchscreen: FCIM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| U0155:87 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message | GO to Pinpoint Test AG |
| U0257:87 | Lost Communication With Front Controls / Display Interface Module: Missing Message |
NOTE:
Despite the description, this DTC applies to the FDIM, not the FCDIM GO to Pinpoint Test AN |
| U2013:63 | Switch Pack: Circuit/Component Protection Time-Out | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incomplete or incorrect FCIM PMI. CHECK the vehicle service history for recent service actions related to the FCIM. If there have been recent service actions with the FCIM, REPEAT/PERFORM the FCIM PMI procedure as directed by the diagnostic scan tool. Refer to: Module Configuration - System Operation and Component Description . See PMI. If there have been no recent service actions, the FCIM has failed to retain configuration data. INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) . |
| U3000:41 | Control Module: General Checksum Failure | This DTC sets due to an incomplete or incorrect FCIM PMI. CHECK the vehicle service history for recent service actions related to the FCIM. If there have been recent service actions with the FCIM, REPEAT/PERFORM the FCIM PMI procedure as directed by the diagnostic scan tool. Refer to: Module Configuration - System Operation and Component Description . See PMI. If there have been no recent service actions, the FCIM has failed to retain configuration data. INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIM. Refer to: Front Controls Interface Module (FCIM) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AO |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AP |