| B00A0:11 |
Occupant Classification System: Circuit Short To Ground |
REFER to: Pinpoint Test - DTC: AQ
. |
| B00A0:12 |
Occupant Classification System: Circuit Short To Battery |
REFER to: Pinpoint Test - DTC: AQ
. |
| B1123:11 |
Restraints Ignition Relay: Circuit Open |
REFER to: Pinpoint Test - DTC: AQ
. |
| B1123:12 |
Restraints Ignition Relay: Circuit Short To Battery |
REFER to: Pinpoint Test - DTC: AQ
. |
| B1142:62 |
Ignition Status 1: Signal Compare Failure |
REFER to: Pinpoint Test - DTC: AR
. |
| B11D9:13 |
Vehicle Battery: Circuit Open |
REFER to: Pinpoint Test - DTC: AR
. |
| B13BF:14 |
Run/Start Input: Circuit Short to Ground or Open |
REFER to: Pinpoint Test - DTC: AR
. |
| U0100:87 |
Lost Communication with ECM/PCM A: Missing Message |
REFER to: Pinpoint Test - DTC: AS
. |
| U0140:87 |
Lost Communication with Body Control Module: Missing Message |
REFER to: Pinpoint Test - DTC: AT
. |
| U1000:00 |
Solid State Driver Protection Active -Driver Disabled |
DIAGNOSE any other BECMB Diagnostic Trouble Codes (DTCs) first. CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If DTC U1000:00 returns, INSTALL a new BECMB. REFER to: Battery Energy Control Module B (BECMB)
. |
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
CHECK vehicle history for recent service actions related to this module. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with this module, REPEAT the PMI procedure as directed by the diagnostic scan tool using As-Built data. |
| U3000:49 |
Control Module: Internal Electronic Failure |
INSTALL a new BECMB. REFER to: Battery Energy Control Module B (BECMB)
. |