Module Configuration and Parameter Chart
The charts describe specific module configuration information:
Direct Configuration
| Module Name | Module Address | Programmable Module Installation (PMI) Available | Reprogram/Flash Capable | Requires Adaptive Learning or Calibration | Available Progammable Parameters |
|---|---|---|---|---|---|
| APIM | 7D0 | Yes | Yes | No | None |
| APIM (Touchscreen) | 7D0 | Yes | Yes | No | Trailer tow Trailer module |
| ABS module | 760 | Yes | Yes | IVD initialization | None |
| ACM | 727 | Yes | Yes | No | None |
| BCM | 726 | Yes | Yes | No | Battery type Cargo door alarm disable (hinged cargo door) Configurable unlocking (hinged cargo door and sliding doors) |
| DDM | 740 | No | No | No | None |
| FCIM | 7A7 | No | No | No | None |
| FCDIM | 7A5 | Yes | Yes | No | Trailer tow |
| GPSM (if equipped) | 701 | Yes | Yes | No | None |
| HCM | 734 | No | No | No | None |
| HVAC module | 733 | No | No | No | None |
| IPC | 720 | Yes | Yes | No | Display language Digital speedometer |
| OCSM | 765 | No | No | OCS re-zero | None |
| PAM | 736 | No | No | No | None |
| PSCM | 730 | No | No | No | None |
| PCM | 7E0 | Yes | Yes | Yes | VIN |
| PDM | 741 | No | No | No | None |
| RCM | 737 | Yes | Yes | No | None |
| SODL | 7C4 | Yes | Yes | No | None |
| SODR | 7C6 | Yes | Yes | No | None |
| SASM | 797 | No | No | No | None |
| TRM (vehicles built before 1/26/14) | 791 | No | No | No | None |
| TRM (vehicles built after 1/26/14) | 791 | Yes | Yes | No | Bad LED configuration LIN bus enable |
Body Control Module (BCM) and Instrument Panel Cluster (IPC) Car Configuration
NOTE:
The BCM and IPC have a unique procedure to set Car Configuration Parameters. Configuration changes made will affect several modules. If the car configuration is changed in the BCM or IPC, an adaptive learning of the car configuration may be required in some modules (such as ABS module or RCM), depending on the changed parameter.
NOTE:
On the scan tool, first select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Retrieve the Vehicle Configuration Data. Next select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Modify and Reinstate Vehicle Configuration Data. Change parameters as needed.
| Module Name | Module Address | Programmable Module Installation (PMI) Available | Reprogram/Flash Capable | Requires Adaptive Learning or Calibration | Available Car Configuration Parameters |
|---|---|---|---|---|---|
| BCM | 726 | Yes (through Car Configuration Parameters. Refer to BCM in Section 419-10.) | Yes | No |
NOTE:
Do not change car configuration parameters except those listed below. Trailer towTrailer moduleGlobal open/closeBulkheadTire sizeBattery type (must also be enabled in BCM direct configuration)Default display language (must also be enabled in IPC direct configuration)Remote start enable/disablePerimeter alarm |
| IPC | 720 | Yes | Yes | No |