Module Configuration and Parameter Chart

WARNING: This page is about a different car, the 2018 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.

The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
APIM	7D0	Yes	Yes	No	None
ABS module	760	Yes	Yes	IVD initialization EPB Apply and Release calibration Brake system pressure bleed	None
ACM	727	Yes	Yes	No	None
AWD	703	Yes	Yes	Automatic torque configuration	None
BECMB	723	Yes	No	No	None
BCM	726	Yes	Yes	Configuration Engine Immobilizer (CEI) configuration (new BCM installation) Battery monitor sensor reset (new BCM installation) Battery reset Customer key programming (minimum 2 keys) LIN device configuration PAM new module initialization (if equipped) TPMS sensor calibration (new BCM installation)	Approach detection Auto relock Auto unlock Courtesy wipe enable/wipe time DRL configuration DRL by autolamps DRL conditions DRL include parklamps Decklid key switch configuration Door key configuration Fog lamp enable Global open/close Low beam enable Keypad enable Lock feedback light Mislock horn One/two stage unlock Park lock control Passive entry/start Piezo sounder feedback Police dark car Power lock enable Power point maxtime/timeout Rain sensing enable Rear wipe reverse wipe Remote start duration Silent mode Static sequence configuration Tire inflation placard front/rear Trim switch inhibit Welcome mat
BCMB (column and pedal control module)	7B7	Yes	Yes	No	None
CCM	764	Yes	Yes	Radar horizontal and vertical alignment calibration	None
DSP	783	Yes	Yes	No	None
DACMC	7D5	Yes	Yes	No	None
DC/ DC converter control module (Voltage Quality Module [VQM])	746	Yes	Yes	No	None
Door latch module-left front (DCME)	7A2	Yes	Yes	No	None
Door latch module -right front (DCMF)	762	Yes	Yes	No	None
Door latch module-left rear (DCMG)	7B3	Yes	Yes	No	None
Door latch module-right rear (DCMH)	7B4	Yes	Yes	No	None
DDM	740	Yes	Yes	Windows initialization	None
DSM	744	Yes	Yes	No	None
FCIM	7A7	Yes	Yes	No	None
GWM	716	Yes	Yes	No	None
GSM	732	No	Yes	No	None
GFM (Remote CD module)	7A1	No	Yes	No	None
HCM	734	Yes	Yes	Leveling Sensor Calibration and Headlamp Aiming	None
HUD module (LED display)	7B2	No	Yes	No	None
HUD module (Driver Information display)	7B2	Yes	No	HUD module calibration	None
HSWM	714	Yes	Yes	No	None
IPC	720	Yes	Yes	No	Remote start enable/disable Climate settings Driver seat Passenger seat Rear defrost Steering wheel
IPMA	706	Yes	Yes	Camera calibration	None
IPMB	7B1	Yes	Yes	360 Degree View Camera Alignment	None
OCS	765	No	Yes	OCSM re-zero	None
PAM (integrated with BCM)	736	Yes	Yes	No	None
PSCM	730	Yes	Yes	No	None
PCM	7E0	Yes	Yes	Misfire Monitor Neutral Profile Correction procedure PATS reprogramming (new module installation only)	None
PDM	741	Yes	Yes	Windows initialization	None
RTM	751	Yes	Yes	No	None
RACM	774	Yes	Yes	No	None
RHVAC module	785	No	Yes	No	None
RGTM	775	Yes	Yes	No	None
RCM	737	Yes	Yes	ABS module initialization SRS prove out	None
Front Passenger Seat Control Module (SCMB)	7A3	Yes	Yes	No	None
SCME (Integrated with DSM)	776	Yes	Yes	No	None
Rear Seat Climate Control Module (SCMF)	777	Yes	Yes	No	None
SCMG	712	Yes	Yes	No	None
SCMH	713	Yes	Yes	No	None
LH Rear Multi-Contour Seat Module (SCMC)	702	Yes	Yes	No	None
RH Rear Multi-Contour Seat Module (SCMD)	763	Yes	Yes	No	None
SODL	7C4	Yes	Yes	No	BLIS enable/disable CTA enable/disable
SODR	7C6	Yes	Yes	No	BLIS enable/disable CTA enable/disable
SASM	797	Yes	Yes	Steering Wheel Angle Trim Steering Motor Angle Trim	None
SECM	7C5	Yes	Yes	No	None
SCCM	724	Yes	Yes	No	Courtesy wipe enable/disable
TCU	754	Yes	Yes	TCU provisioning (module reset or ignition key cycle)	None
TRCM	711	No	Yes	No	None
VDM	721	Yes	Yes	No	None