Module Configuration and Parameter Chart
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
The chart describes specific module configuration information:
| Module Name | Module Address | Programmable Module Installation (PMI) Available | Reprogram/Flash Capable | Requires Adaptive Learning or Calibration | Available Progammable Parameters |
|---|---|---|---|---|---|
| APIM | 7D0 | Yes | Yes | No | Travel Link (touchscreen with navigation) |
| ATCM (Raptor) | 792 | No | No | No | None |
| ABS module | 760 | Yes | Yes | IVD initialization | None |
| ACM | 727 | Yes | Yes | No | Auxiliary 1 Engine noise enhancement enable/disable |
| BECMB | 723 | Yes | Yes | No | None |
| BCM | 726 | Yes | Yes | Ambient lighting calibration Rear view camera calibration |
Approach detection Autolamp delay Auto lock/unlock Auto relock Bed lamp enable/disable Body manufacture code configuration DRL configuration DRL by autolamps configuration Global open/global close Keypad enable Lock feedback light Mislock horn One/two stage unlock Park lock control Perimeter alarm Piezo Sounder feedback Police dark car feature Power lock enable Power point max time/time out Rain sensing enable Rear fold mirror Remote start enable/disable Trim lock/unlock configuration Valet mode |
| CCM | 764 | Yes | Yes | Radar horizontal and vertical alignment calibration | None |
| DSP | 783 | Yes | Yes | No | None |
| DACMC (integrated with ACM) | 7D5 | Yes | Yes | No | None |
| DC/ DC control module (voltage control module [VQM]) | 746 | Yes | Yes | No | None |
| DDM | 740 | Yes | Yes | Windows initialization | None |
| DSM | 744 | Yes | Yes | No | None |
| SCMG | 712 | Yes | Yes | No | None |
| SCME (integrated with DSM) | 776 | Yes | Yes | No | None |
| FCDIM (4.2-inch screen) | 7A5 | Yes (vehicles NOT equipped with SYNC) | Yes (vehicles NOT equipped with SYNC) | No | None |
| FCIM | 7A7 | Yes | Yes | No | None |
| GWM | 716 | Yes | Yes | No | None |
| HUD module | 7B2 | No | No | No | None |
| HSWM | 714 | Yes | Yes | No | Temperature setpoint Low Medium High |
| IPC | 720 | Yes | Yes | No | Automatic regeneration control (diesel only) Manual regeneration control (diesel only) Remote start feature configuration Climate settings driver seatpassenger seatsteering wheel Trailer brake gain warning Trailer brake controller |
| IPMA module | 706 | Yes | Yes | Camera calibration | None |
| IPMB | 7B1 | Yes | Yes | Camera calibration LIN new model initialization |
None |
| OCSM | 765 | No | No | OCSM re-zero | None |
| PAM (integrated with BCM) | 736 | Yes | Yes | No | None |
| SCMH | 713 | Yes | Yes | No | None |
| PSCM | 730 | Yes | Yes | No | None |
| PCM | 7E0 | Yes | Yes | Misfire Monitor Neutral Profile Correction procedure (except Diesel) PATS parameter reset |
None |
| PDM | 741 | Yes | Yes | Windows initialization | None |
| PRB | 766 | No | No | No | None |
| RTM | 751 | Yes | Yes | No | None |
| RCM | 737 | Yes | Yes | No | Driver Beltminder status Passenger Beltminder status |
| SODL | 7C4 | Yes | Yes | No | BLIS/ CTA enable/disable |
| SODR | 7C6 | Yes | Yes | No | BLIS/ CTA enable/disable |
| SCCM | 724 | Yes | Yes | No | None |
| TCU | 754 | Yes | No | No | None |
| TBM | 757 | No | No | No | None |
| TRM | 791 | Yes | Yes | No | None |
| TCCM | 761 | Yes | No | No | None |
| TCM (10R80 transmission) | 7E1 | Yes | Yes | Transmission Strategy Download | None |
| VDM | 721 | Yes | Yes | Suspension height sensor calibration | None |