Module Reprogramming

Module reprogramming (also referred to as flashing) is a scan tool process which updates the strategy/calibration in a module. Reprogramming a module with the same level of software does not improve module operation or repair a hardware failure. Module reprogramming is automatically carried out during PMI when a later strategy/calibration is available.

Limit module reprogramming to circumstances where a published TSB, GSB, SSM or FSA recommends doing so.

A module cannot communicate with other modules on the communication network while being reprogrammed. After the reprogramming process, clear any network communication Diagnostic Trouble Codes (DTCs) which may have been set in other modules.

Some modules are reprogrammed in coordination with other modules.