LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2021 >> Explorer ST >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Module Configuration >> General Procedures >> Module Programming >> Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module Programming: Programming

NOTE: If the diagnostic software does not load or if the vehicle cannot be identified properly, make sure there is a good internet connection and the VCM II or VCMM is properly connected to the DLC.
  1. Log into FDRS.
  2. NOTE: Vehicle information is automatically retrieved by the diagnostic software and a Network Test is run. Vehicle identification data appears on the screen when this is complete.

    Click 'Read VIN from Vehicle' or manually enter the VIN.

  3. NOTE: Available modules are shown on the LH side of the screen, and available procedures are listed on the RH side of the screen. Modules that are communicating are highlighted in green.

    Select Toolbox tab.

  4. NOTE: If a module is integrated within another module, both modules will automatically program during this process. For example, if the ACM is selected, the DACMC (if integrated with the ACM) is also programmed.

    From the list on the LH side of the screen, select the module that requires a programming procedure to be completed.

  5. From the list on the RH side of the screen, select PMI or Module Configuration.
  6. Click RUN. Follow all on-screen instructions carefully.
scientia non olet · About LEMON Manuals