LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2021 >> Explorer Timberline >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Module Configuration >> General Procedures >> Module Programming >> Recovery
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module Programming: Recovery

NOTE: Perform the following steps when programming has resulted in a blank module.
  1. Disconnect the VCM II or VCMM from the DLC and PC.
  2. Launch FDRS and log in.
  3. In the Device Manager window that populates, select CANCEL.
  4. Select the appropriate VIN from the Vehicle Identification menu or use Manual VIN Entry and select GO.
  5. In the Vehicle Communication Device Not Detected window that populates, select CONTINUE. If a Device Explorer window populates, select CANCEL.
  6. After the session has started, reconnect the VCM II/ VCMM to the DLC and the PC. The VCM II/ VCMM icon should turn green in the bottom right corner of the screen. If it does not, troubleshoot the FDRS to VCM II or VCMM connection.
  7. In the Toolbox menu, navigate to the failed module and Download/Run PMI. Follow the on-screen prompts. When asked if the original module is installed, select NO and continue through the installation application.
  8. Once programming has completed, a screen may list additional steps required to complete the programming process. Make sure all applicable steps are followed in order.
scientia non olet · About LEMON Manuals