Module Configuration and Parameter Chart

The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
APIM	7D0	Yes	Yes	No	None
ABS module	760	Yes	Yes	IVD initialization RCM: Longitudinal acceleration sensor calibration SASM: Steering angle sensor calibration	None
ACM	727	Yes	Yes	No	None
BCM	726	Yes	Yes	Anti-theft parameter reset BBS (battery backed sounder), CSM (combined sensing module), ESCL (electronic steering column lock), rear parking aid camera LIN learning routines BMS reset ESCL configuration/training procedure TPMS calibration	None
BECMB	723	Yes	Yes	No	None
DACMC (integrated with ACM)	7D5	Yes	Yes	No	None
DCME	7A2	No	Yes	No	None
GWM	716	Yes	Yes	No	None
GSM	732	No	Yes	No	None
HUD module (shift indicator)	7B2	No	No	No	None
HVAC module	733	No	No	Door actuator position calibration	None
IPC	720	Yes	Yes	No	None
OCS Module	765	No	No	OCS reset	None
OCS Translator	-	No	No	No	None
PCM	7E0	Yes	Yes	Anti-theft parameter reset Misfire Monitor Neutral Profile Correction	None
RTM	751	Yes	Yes	No	None
RCM	737	Yes	Yes	Longitudinal Acceleration ABS routine	None
SASM	797	No	No	ABS to SASM training	None
SCCM	724	Yes	Yes	No	Courtesy wipe enable/disable
TCU	754	Yes	Yes	No	None
TCM	7E1	No	Yes	NVM clear TCM adaptive learning/teach-in calibration	None
VDM	721	No	Yes	No	None