DTC U3000: Control Module
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2018 Lincoln MKZ, 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, and 2018 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.
| Failure | Action |
|---|---|
| 1E | This DTC sets if the current on the clockspring tape high power circuit is between 8A and 17A and the resistance ratio crosses the upper or lower threshold. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC and then CARRY OUT the SASM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 42 | This DTC sets due to an internal failure of the SASM. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC and then CARRY OUT the SASM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 45 | This DTC sets due to an internal failure of the SASM. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC and then CARRY OUT the SASM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 49 | This DTC sets due to an internal failure of the SASM. CARRY OUT the SASM Module Reset routine. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC and then CARRY OUT the SASM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 96 | This DTC sets due to an internal failure of the SASM high power circuit FET. CYCLE the ignition from ON to OFF and back to ON. CLEAR the DTC and then CARRY OUT the SASM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |