Inoperative Cruise Control
NOTE:
Make all tests with transmission shift lever in "PARK" position and parking brake "ON".
- Check "Gauges" fuse. If fuse is blown, check speed control wiring for short circuit. If fuse is not the problem and Erratic Cruise Performance Trouble Shooting checks out O.K., turn ignition to "RUN" position. Slide "CRUISE" switch to "ON" position.
- Disconnect the 2 wire connector from transducer. Connect 12 volt test light to "Engage" terminal in connector and ground. Repeat using "Hold" connector terminal.
- If test light was off in step 2), check for open circuit in wire. See Fig. 1. Perform "SET-COAST" Switch Test. If test light is on in step 2), check to make sure transducer is well grounded. If transducer is grounded, remove it for repair.
- If test light was off in steps 2) and 3), check for open circuit in Brown wire, between engagement switch connector and brake switch. Check brake switch for voltage at both terminals, with ignition in "RUN" position and "CRUISE" switch in "ON" position.
- Check for open circuit in wire from brake release switch to "CRUISE" switch and fuse panel plug-in. Check engagement switch operation, and replace if necessary.