LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 1983 >> Forward Control 6.2 J, Standard >> Repair and Diagnosis >> Engine Performance >> Ignition System - HEI >> Testing >> Electronic Spark Control (ESC) Testing >> Engine Starting Problems
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Starting Problems

  1. Check all ESC harness connections, including 10-pin connector, 4-pin connector at distributor, 2-blade male connector to distributor, and 2-blade female connector to ignition switch lead (Pink wire). Repair as necessary.
  2. If all connections are OK, disconnect 4-pin connector at distributor. Install jumper wire between pins "A" and "C" of distributor connector. If engine will not start, check other causes of engine failing to start.
  3. If engine starts with jumper wire attached, remove jumper wire and reconnect 4-pin connector to distributor. With ignition switch "ON", connect voltmeter positive lead to pin "F" and negative lead to pin "K" on 10-pin connector. If under 7.0 volts, repair circuit between ignition switch and pin "F".
  4. If over 7.0 volts are read, check wires in ESC harness from pins "G", "H", "J" and "K" of 10-pin connector for opens or shorts. If harness is OK, replace ESC controller.
scientia non olet · About LEMON Manuals