TPS Check
The throttle position sensor (TPS) is a variable resistor that signals the ECM the degree of throttle opening. Sensor is connected to 5-volt reference and has the highest resistance at closed throttle position. At wide open throttle position, resistance is lowest and output to the ECM will be about 5 volts.
NOTE:
The following step numbers refer to the numbers in the accompanying flow chart(s).
- This step checks for complete 5-volt reference circuit. If circuit is complete from voltage reference and back to sensor ground in ECM, a voltage reading of about 5 volts should be measured.
- This step checks for shorted or stuck 4th gear switch. When the transmission shifts into 4th gear, the switch will close and signal the ECM to turn EGR off. If the 4th gear switch is not faulty, there could be a short to voltage reference or a faulty TPS adjustment or sensor.
- This step checks for normal response at ECM from TPS. Voltage should normally be less than 1 volt at closed throttle and go to about 5 volts at wide open throttle. If voltage change is okay, circuit is complete.