Test Description
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Code 42 means the ECM has seen an open, or short to ground, in EST or by-pass circuit. This confirms Code 42, and confirms that fault causing the code is also present.
- Checks for normal EST ground path through ignition module. An EST circuit No. 423 shorted to ground will also read less than 500 ohms (will be checked later).
- As test light voltage touches circuit No. 424, module should switch, causing ohmmeter to "overrange" if meter is in the 100-200 ohms position. Selecting 10-20,000 ohms position will indicate above 5000 ohms. The important thing is that the module "switched".
- The module did not switch and this step checks for:
- EST circuit No. 423 shorted to ground.
- By-pass circuit No. 424 open.
- Faulty ignition module connection or module.
- Confirms that Code 42 is a faulty ECM and not an intermittent in circuit No. 423 or circuit No. 424.