Only Right Hand Power Window Inoperative From Either Switch
- Disconnect RH power window motor connector. Check for continuity between Dark Blue wire and ground, and then between Brown wire and ground. If there is continuity in both cases, go to next step. If there is no continuity on one or both wires, go to step 3).
- Turn ignition switch to RUN and move RH switch to UP position. Check for battery voltage between Dark Blue wire and ground. If battery voltage is present, replace RH power window motor. If battery voltage is not present, go to step 4).
- Disconnect harness 3-pin, (or 6-pin), connector (behind RH side of instrument panel. Check for continuity between Blue/White, (or Dark Blue/White), wire at crossbody half of harness connector and ground. Repeat for Tan/White wire. If there is continuity on both wires, check continuity of RH power window switch. See WIRING DIAGRAMS . If there is no continuity on one or both wires, go to step 5).
- Disconnect harness 3-pin, (or 6-pin), connector (behind RH side of instrument panel. Check for battery voltage between Pink wire at crossbody half of harness connector and ground. If battery voltage is present, check continuity of RH power window switch. Refer to WIRING DIAGRAMS . If battery voltage is not present, repair open in Pink wire.
- Disconnect harness 6-pin, (or 8-pin), connector behind LH side of instrument panel. Check for continuity between Blue/White, (or Dark Blue/White), wire at crossbody half of harness connector and ground. Repeat for Tan/White wire. If there is continuity on both wires, Repair open in appropriate wire. If there is no continuity on one or both wires, check continuity of LH power window master switch. See WIRING DIAGRAMS .